Emotiva Fusion Flex, Руководство пользователя

Страница: 18 / 26

Page 14
Fusion Flex Amplifier
Operation
Turning on the AC power
The AC mains power on the Fusion Flex Amplifier is controlled by the Power rocker switch located
on the rear panel above the power cable. When the AC mains power is Off, the Fusion Flex Amp
will not respond to any command (but it will remember Volume and Input settings.) Once the
AC power is turned on, the Fusion Flex Amp will remain in Standby mode until:
• the Standby push button on the front panel is pressed.
• the Trigger Input is asserted (if the Power Mode switch is in Trigger mode).
• audio signal is sensed at an input (if the Power Mode switch is in Auto mode).
• the Standby button on the IR remote is pressed
(or the code is received from a compatible control).
• the Power On command is received from an RS-232 serial device.
The PA 2-50 will then remain On until:
• the Standby push button on the front panel is pressed again.
• the Trigger Input is dropped (if the Power Mode switch is in Trigger mode).
• audio signal is no longer sensed at an input - after a short delay
(if the Power Mode switch is in Auto mode).
• the Standby button on the IR remote is pressed
(or the code is received from a compatible control)
• the Power Off command is received from an RS-232 serial device.
The Power Mode switch is the small bat switch on the rear panel labelled “On/Auto/Trigger”.
Status Indicators
When the Fusion Flex Amp is in Standby mode, the single LED next to the front panel Standby
switch will be lit red; when the Fusion Flex Amp is On, the LED will be lit blue; if a fault occurs, the
LED will flash red (and all other LEDs will be off).
Selecting an Input
To select in input using the front panel controls, press one of the Input Selector buttons
(1, 2, or Auto). Pressing 1 or 2 directly selects that input; pressing Auto configures the Fusion
Flex Amp to use whichever input is active. If both inputs have audio signal on them, Input 1
takes priority and will be selected. If only a single input is to used, it should be Input 1. The same
input commands may be received via the included IR remote control, a programmable IR remote
configured with the correct codes, or a remote control device connected to the RS-232 serial port
on the rear panel of the Fusion Flex Amp.