Emotiva DMC-1, Руководство пользователя

Страница: 86 / 96

Page 86
Noise bursts are heard when DTS encoded CDs or LDs are played. Compressed DTS data
uses the normal digital audio tracks of CDs and LDs. This analog noise may be heard in your
system before the DTS digital signal is locked on, or it may appear as a background hiss. To
reduce or prevent this noise, disconnect any analog connections to your CD, DVD, or Laserdisc
players. Just use the Digital connections and see if this addresses the problem.
No On Screen Display
See page 50 and 61
Press the remote’s MENU button to activate the OSD. It should be present even when no
video source has been selected. Remember, there is no OSD “Pop Up” for component video
connections.
Sound drops out with CD or DVD playback
Make sure the disc is not dirty or scratched.
Some inexpensive players and changers tend to mistrack more often, causing dropouts with
an external DAC.
Remote Won’t Learn Commands or Codes
See page 45
Make sure you are pointing the original remote into the receiving window of the Emotiva
remote. This is located on the top edge of the remote.
Try touching and holding the first button to be learned.
Do not do the learn procedure in bright lighting or sunlight.
Make sure the Emotiva remote is correctly in its LEARN mode.
Make sure the batteries in the remote are fully charged.
Try varying the distance between the remotes from 1 to 2 inches, and see if the learn proce-
dure improves.
Remote Not Working
See pages 43-49
Make sure the batteries are not dead, or installed incorrectly.
Make sure the remote is set on the correct device display for the component you are trying to
control.
Make sure that the buttons have not been erased or learned over.
Make sure that the DMC-1 front panel receiver window is not obstructed.
Check that the front or rear IR receivers have not been turned off in the OSD CONTROL
menu.