Emotiva BASX PT-100, Руководство пользователя

Страница: 13 / 32

Page 9
BasX PT-100 Stereo Preamp / DAC / Tuner
BasX PT-100 Rear Panel
1. Phono Input Ground Lug
Connect the ground lead from your turntable to this lug to avoid or eliminate hum problems.
Note: Some turntables may not provide a separate ground lead. You may also find that, even
on some turntables that provide a ground lead, you get less hum when it is disconnected.
2. Phono Input Gain Selector
Use this switch to set the gain of the PT-100’phono input to match the output of your cartridge.
Normally this switch should be set to MM for a moving magnet cartridge, and to MC for a moving
coil cartridge.
Note: The manufacturers of some phono cartridges may instruct you to set the gain switch to
MM for a “high output moving coil cartridge”; always follow manufacturer’s recommendations.
3. Phono Input
Use this input to connect the output from your turntable.
Note: This input is intended to accept the low-level output from a moving magnet or moving
coil phono cartridge, and includes RIAA phono equalization. DO NOT connect a line level source
to this input or the sound will be distorted and you may damage your PT-100. If your turntable
has a built-in phono preamp, and provides a line level output, then you should connect it to one
of the line level inputs on the PT-100 (CD or Aux).
4. Line Level Unbalanced Stereo Inputs
The CD and Aux inputs are unbalanced line level inputs, and may be used to connect a stereo line
level signal from any analog stereo audio source. The CD and Aux inputs are similar, and either
may be used to connect any component that delivers a standard line level audio signal.
4 6 5 7 1 3 2
PT-100
PHONO
GROUND
PHONO CD AUX SUB MAIN
MC MM
L
R
L
R
MONO
115V 230V
POWER
AC INPUT
8
ANALOG INPUTS ANALOG OUTPUTS
ANTENNA COAX OPT USB BT
DIGITAL INPUTS FM
TRIG
OUT
POWER
10 11 12 9