Emotiva Airmotiv S8, Руководство пользователя

Страница: 17 / 28

Page 13
AIRMOTIV S8 F
lex
S
ubwOOFeR
System Configuration #1
System: A surround sound preamp/processor, A/V receiver, or stereo preamp, with
built-in bass management and a subwoofer output.
Connections:
• Connect the subwoofer output of your AVR, processor, or preamp to the LFE Input on
the Flex Subwoofer. If your source component has stereo subwoofer outputs, you may use
the separate Left Input and Right Input on the Flex Sub. If your source component only
has a balanced subwoofer output or outputs you may need to purchase a low cost passive
balanced-to-unbalanced adapter or adapter cable.
Configuration:
• Set the Power switch to Auto so your Flex Sub will turn on automatically when the music
starts.
• Set the Volume control to its center position.
• With the Phase switch, try both settings, and leave it set in the direction where you hear the
most low bass at your listening position.
• Set the X-Over control to its highest setting (fully clockwise, 150 Hz).
• The setting on the High-Pass Crossover Frequency switch doesn’t matter.
Notes:
• Connect your main power amp and speakers as you normally would.
• Follow the instructions on your AVR or processor for adjusting the bass management, or for
using their built-in room correction software.
A
+
-
60 HZ
80 HZ
100 HZ
OUT IN
L
R
LFE
L
R
HIGH LEVEL IN
POWER AMPLIFIER PREAMP / PROCESSOR
INPUT MAIN
OUTPUTS
SUBWOOFER
OUTPUT