Emos P5763R, Руководство пользователя

Страница: 4 / 76

4
GENERAL SETTINGS
Ringtone Selection
You can change the ringtone at any time (except for when the doorbell is
in self-learning mode).
The pairing of the chime with the button is not affected by ringtone change.
1. Remove the rear cover by inserting a screwdriver into the hole on the
side of the button.
2. Repeatedly press the B button on the printed circuit of the button. Each
press will play a different ringtone.
3. You can set a different ringtone for each paired button to better identify
which button was pressed to ring the chime.
4. Re-assemble the button.
Setting Chime Volume
Repeatedly press the button located on the side of the chime.
Each press will set a different volume level in the following order:
100 % – 75 % – 50 % – 25 % – 0 % – 25 % – 50 % – 75 % – 100 %
Setting Ringing Mode
Repeatedly press the button located on the side of the chime.
Each press sets a different ringing mode:
1. Acoustic signalisation only
2. Optical signalisation only
3. Ac optical signalisation
Note: Ac optical signalisation is the default ringing mode.
This mode will be set automatically if power supply to the chime is interrupted.
Indication of Low Battery in the Chime & Signal Extender
If a red LED is constantly glowing on the chime, it means the batteries are flat.
Replace the chime batteries with new ones as soon as possible.
USAGE AS A REPLACEMENT/SUPPLEMENTAL CHIME
Pairing the Button with the Chime
1. Remove the rear cover of the button by inserting a screwdriver into
the hole on the side (see Fig. 3). Insert a 3 V battery, type CR2032, into
the button. When inserting the battery, make sure to observe correct
polarity (+ polarity up)!
2. Insert 3× 1.5 V AA batteries into the battery compartment of the
doorbell (use alkaline batteries only). You will hear a “ding dong” tone.
The chime automatically switches to self-learning mode which lasts for
60 seconds.