23
Set Changing Value Parameter:( Default = 3 )
Changing value for Set value is determined with this parameter.
Set changing value become one(1)
Set changing value become ten(10)
Set changing value become hundred(100), for each pressing the
Increment, Decrement button
Set changing value become incremental. (Note-1)
Analogue Output Range Selection Parameter:( Default = 0 )
Analogue output range is determined with this parameter
according to the device type 0...10V
or 0...20mA
according to the device type 2...10V
or 4...20mA
Z
Z
Z
Z
(2)
(1)
(1)
(2)
Adjustment Section Accessing Password:
Required password is entered via this parameter for accessing to the
adjustment section. If the parameter value is entered as 3083, screen
is accessed, otherwise parameter is seen
Adjustment Value Parameter:
Adjustment value for Analogue output. It can be adjusted from 0 to 4095.
When pressing button on screen, adjustment value is seen on
screen. The value on the screen should be adjusted with Incremet and
decrement button until 10.00V
or 20.00mA
s obtained from the
analogue output.
After getting the 10.00V
or 20.00mA
Z
Z
i
Z Z
on analogue output, press
button for saving this value as an adjustment value
Programming Section Accessing Password:( Default =0 )
It is used for entering to the programming section.
It can be adjusted from 0 to 9999. If this password is 0, programming section
can be accessed without entering the password.
(2)
(1)
SET
(1)
(2)
i
It is valid, if the device type 0/2...10V
It is valid, if the device type 0/4...20mA
Z
analogue output.
Z
analogue output.
(1)
(2)
Note-1:
If increment or decrement button is pressed for 2 seconds continuously, increment and
decrement number become 10, if pressed for 4 seconds continuously, increment and decrement
number become 100, if pressed for 6 seconds continuously, increment and decrement number
become 1000.
