TB-6594
Page 11 of 12
© 2016 DESCO INDUSTRIES, INC.
Employee Owned
Operation
NOTE: The SmartLog Pro™ must first be programmed
with the user ID table using the TEAM5 Software before
being deployed for employee use, or the default test
settings will be applied.
See the
TEAM5 User Manual
for more information.
If the SmartLog Pro™ is located near a restroom,
sink or other water source, operators will need to be
instructed to thoroughly dry their hands before testing.
Wet hands may cause inaccurate test results and
damage to the tester.
1. Initiate the test procedure by identifying yourself
to the SmartLog. This may be done using the
touchscreen keypad, barcode badge scanner or
proximity badge reader.
NOTE: Hold the proximity badge in front of the RFID
icon for a full second if using proximity badges. See
Figure 20.
2. Follow the prompt on the SmartLog’s display.
3. When performing a footwear test, be sure to place
both feet on the dual foot plate (one foot per plate).
NOTE: Keep the foot plate clean with 99% isopropyl
alcohol when using the 1 Gigohm high test limit. A
dirty foot plate could yield a false pass.
When performing a wrist strap test, be sure to
completely plug in the wrist cord into the tester’s
jack.
4. Press and hold the test switch to perform the test.
Hold your finger on the test switch until the results
of the test are displayed.
If performing a wrist strap test, and the wrist strap
status LEDs do not illuminate, verify that the wrist
cord is correctly inserted into the tester.
Figure 19. Using the barcode scanner
Figure 20. Holding a proximity badge in front of the
RFID icon on the SmartLog Pro™
Figure 21. Performing a test with the SmartLog Pro™
5. The relay terminal will activate if the defined tests
are passed (if applicable).
