EMIT ESD2, Руководство пользователя

Страница: 5 / 10

Operating modes
"ESD2" is displayed at the top line and the version number is shown at the
bottom line,for a few seconds at startup. Then ESD2 switches to last used
operating mode (the mode that was used before it was turned off last time).
Cycle through the operating modes by pressing the 'Mode'-key.
ESD2 has three operating modes:
Clock only
Actual time (hh: mm: ss) is displayed on the top line,
nothing appears on the bottom line.
Interval start without startno.
Actual time (hh: mm: ss) is displayed on the top line,
start number and countdown of seconds to next start is
shown on the bottom line. The start time and the starting
interval is entered manually by the keyboard.
Pursuit / interval start with startno.
Actual time is shown on the top line.
Next startno. and countdown appears on the bottom line.
Start times, startno and startbooth no. are transfered from
a textfile using the supplied program; EmitESD2 .
If the start number has too many digits to be shown, only
the countdown is displayed.
ESD2 Finish Display
It possible to order ESD2 as a finish display, with the 'Loop1'-output enabled.
This makes it possible to show the finsh-time, or lap-time, for a competitior on the
display. To activate the communication with the emiTags, connect the included
eLine loop to the 'Loop1'-output.
Press the 'Interval'-key followed by 1379 and 'enter' to start the finish-display
mode. In this mode ESD2 will show the used time (tag time) for a few seconds
for each emiTag registered. It is also possible to display lap-times, instead of
finish-times, on the ESD2. To start the «lap-time mode» press the 'Interval'-key
followed by
1397 and 'enter'.
Press the 'Mode'-key to exit finish-display mode.