12
EM-210DVI/410DVI
Connecting the Computers
1.Using Emine's DVI cable set with Audio (Part No. KIC6A) connect the USB
cable from the computer's USB port to the USB port on the KVM Switch.
2.Connect the male end of the DVI cable to the DVI port on the computer.
Connect the other end of the male DVI cable to the KVM switch for PC1.
3.Take the audio cable and connect one end of the male (3.5mm) plug to the
"Speaker" jack of your computer. Connect the other end of the cable to the
"Audio" jack (as designated by the "Audio" symbol) on the back of your KVM
Switch. Do the same for the "Microphone" connection. (Step 3 is optional and
is not required to use the DVI-KVM Switch.)
EM-210DVI/410DVI
11
4.Repeat steps 1 through 3 for all computers.
5.Power on your computers, and refer to the operation instructions.
Note:
Audio and microphone support is designed on a one-computer-at-a-time
basis.
OPERATION
Powering Up the Systems
Once all cables have been connected and all computers have been powered up
the Switch emulates mouse and keyboard signals on each port allowing your
computer to boot normally. Your EM-210DVI/410DVI is now ready for use.
Controlling your computers with the Emine's DVI KVM couldn't be easier. The
EM-210/410DVI allows you to access the computers using:
Logically designed Manual Port Selectors or
Simple Hot Keys from the keyboard
Selecting Computers via Manual Port Selectors
You can instantly select any computer by pressing the port-selectors on the
front of the KVM Switch. The corresponding LED will light "Green" to indicate
current port selection.
Selecting Computers via Hot Keys
You can directly switch the KVM focus to any computer via the simple keyboard
command sequence using the "Scroll Lock" key and entering the switch port
number. Each computer is assigned a numeric ID.
1.To invoke the Hot key mode press the
"SCROLL LOCK"
key twice within two
seconds. Note that a signal 'beep' will be given as confirmation.
2.Enter your desired switch port number (1-4).
For example, if you press
[SCROLL LOCK]
,
[SCROLL LOCK]
, "2" the
computer on port 2 will be selected.
