![Emicon EMIBYTE DXi.H Скачать руководство пользователя страница 49](http://html1.mh-extra.com/html/emicon/emibyte-dxi-h/emibyte-dxi-h_use-and-maintenance_2401334049.webp)
Rev. 3 02-2021
49
MTEC.DXi.H/DXi.HF.GB-3 Use and Maintenance technical manual DXi.H/DXi.HF English
Emibyte DXi.H/DXi.HF
Direct expansion close control
:KHQWKHLQWHUQDO(0&¿OWHULVGLVFRQQHFWHGLILVQRWLQVWDOOHGDQH[WHUQDO¿OWHUWKHIUHTXHQF\FRQYHUWHUGRQRWPHHWVWKHHOHFWURPDJQHWLF
compatibility requirements.
To EMC disconnection remove the EMC screw.
1) Connect to ground the PE conductor on distribution schede.
2) Use an additional ground connection wire if the shielding is inadequate (lower than conductivity of phase conductor) and there is not a
simmetric ground conductor inside the wire.
6XSSO\FDEOHFRQQHFWLRQ
566HULDOLQWHUIDFH
Supervision system connection (MODBUS-RS485 only suprevision system available).
This system allows control all the unit operation parameters by remote and allows also the possibility to change them.
It is necessary to respect the wiring polarity how shown below; The polarity inversion could cause a unit malfunction. The supervision sy-
stem cable should be twisted type and shelded with 2 wire AWG20/22.
Unit is factory settled with serial address 1; if MODBUS protocol is used there is the possibility to ask the variables list to the Manufacturer.