Emhart Teknologies
- 50 Shelton Technology Center, Shelton CT 06484 - Tel. (203) 924-9341 - Fax (800) 225-5614
Page
3
1.
DO NOT
use this tool in a manner other than that recommended by Emhart Teknologies.
2. Always wear eye protection. When using the tool both the operator and any person(s) in the
vicinity are required to wear eye protection to protect against injury.
3. Inspect tool for damage before connecting to air supply.
4. Trained personnel must perform tool repair and/or maintenance at the prescribed intervals
for damage and functionality.
5. Disconnect the air supply when adjusting, servicing or removing any part of the tool.
6. Keep your fingers off of the trigger when connecting the air supply.
7. Keep your fingers away from the front of the tool when connecting the air supply or setting
rivets.
8.
DO NOT
point the tool at any person(s) or the operator.
9.
DO NOT
operate tool with nose housing removed.
10.
DO NOT
operate tool without deflector or MCS options.
11.
DO NOT
modify the tool in any way. In addition to voiding any applicable warranties,
unauthorized modifications can result in damage to the tool or physical injury to the user.
12.
DO NOT
look into the tool from the front or the back during use. Rivets or expended
mandrels may be ejected resulting in injury.
13. The operating pressure shall not exceed 100 psi (6.9 bar).
14.
DO NOT
direct tool exhaust towards anyone.
15. If there is excessive contact with hydraulic fluid or lubricants, care should be taken to wash
thoroughly.
16. Take care to keep hair, fingers and loose clothing away from moving parts of the tool to
avoid entanglement and/or physical injury.
TO INSURE PROPER FUNCTIONING AND SAFE OPERATION READ THIS MANUAL
CAREFULLY BEFORE SETTING UP OR OPERATING THE ProSet™ 2100 SERIES TOOLS
Safety Instructions
