98153 US 3.2 - 12 2010
11 / 18
www.santos.fr
FAULT FINDING
Carefully determine the reason for the appliance stopping.
In all circumstances, if the problem persists, switch off the appliance (unplug the mains
power cord plug (
10
)) and call on someone from the maintenance department or contact an
approved SANTOS dealer.
The appliance does not start
Check: the mains power supply and the condition of the power cable (
10
).
Check that the luminous indicator lamp at the outlet of the crushing unit (
9
) goes on
for approximately ten seconds when the appliance is connected to the mains power
supply.
Check that there is no foreign matter stuck between the blades.
Inside the appliance, check the condition of the electric wires and connections (at the
grommet (
12
) and the connection block (
13
) (fig. F)
Check the electrical components by changing them one at a time (capacitor, cover
safety device, electronic module, motor).
The machine stops because the motor has overheated: (the motor unit is hot)
In the event of the motor overheating, the appliance will stop automatically.
The protection device is reset automatically, wait for the motor to cool down (15 to 30
seconds) before starting the machine back up.
The appliance stops further to an overload
Foreign matter between the blades and intensive use can lead to motor overload.
Under these circumstances, either the thermal protection or the excess current protection
may be activated and stop the machine operating.
If the machine is hot, refer to the section
"The machine stops because the motor has
overheated"
.
If not, refer to the
"motor overload safety feature"
section.
The appliance continues to operate after processing all the ice cubes
In automatic mode, the appliance operates according to a non-adjustable timer set to 1
minute (time required to process a whole hopper load on small size).
Press the button which is lit up in order to go back to manual mode and stop the appliance.
Both buttons flash simultaneously
The appliance stops further to a motor overload. To overcome this, refer to the
"motor
overload safety feature"
section.
408095 en ma 2010.12
10/17
Содержание 408.095
