VOLUME
B122rH
VOLUME
B122rH
TONE
B124rH
OUTPUT CABLE
MASTER
TONE
OUTPUT CABLE
Like all EMG Accessory products, the AB uses EMG’s 5-pin connector.
Diagram #1 to the right shows how the plug-in connectors are installed.
Be sure to reverse the input connector as shown.
Diagrams #2 and #3 illustrate installations that have a single pickup and
do not use a selection switch.
Page 3 has diagrams that have 2 pickups and a selection switch.
Page 4 has diagrams that have 3 pickups and use the B161 five position
selection switch/buss. If you have the B161, refer to that data sheet where
more options regarding the 3-pickup instruments are available.
Keep in mind that all of the EMG Accessory controls can be substituted for one
another since they all have buffered inputs and utilize the same 5-pin connnector.
So, if you decide you would like to use an EXG rather than the AB, simply unplug
the AB and replace it with the EXG.
Installation Instructions:
EMG Model: AB (Afterburner)
AB (Afterburner) Page 2
Note: Reversed connector! Pins 1 and 2 are reversed.
Make sure the connectors are plugged on as shown.
All of the EMG Active controls use the same 5-pin connector
shown below.
Input
Output
Volts +
Diagram #1
Diagram #3
One Pickup
One Volume
One Master Tone (Passive)
One AB Control
OUTPUT
T
R
S
FROM PICKUP
BATTERY
NEG (-)
RED
RED
BATTERY
BUSS
OUTPUT CABLE
- 9V +
Diagram #2
One Pickup
One Volume
One AB Control
OUTPUT
T
R
S
FROM PICKUP
BATTERY
NEG (-)
RED
RED
BATTERY
BUSS
OUTPUT CABLE
MASTER
VOLUME
- 9V +
RED
RED
AB
NOTE:
REVERSED
CONNECTOR
AB
MASTER
VOLUME
NOTE:
REVERSED
CONNECTOR
AB
