23
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF590
12. Light Kit LED Array Assembly Replacement
(Continued)
12.4
Disengage the fan motor assembly 2-pin wire connector
from the 2-pin wire connector of the Light Kit Assembly
(Figure 40).
12.5
Install new Light Kit Assembly by following the assembly
instructions in Section 5, Steps 5.1 through 5.4.
Restore electricity and verify function of the Light Kit.
LIGHT KIT ASSEMBLY
2-PIN CONNECTOR
FAN MOTOR
ASSEMBLY
2-PIN CONNECTOR
Figure 40
13. Light Kit LED Driver Replacement
13.1
Disconnect electrical power to the branch circuit at the
circuit breaker or fuse box before attempting to remove the
ceiling fan from the mounting bracket.
The Light Kit Driver is located in the motor assembly.
The entire ceiling fan will have to be unwired and
removed from the ceiling outlet box.
If you feel that you do not have enough electrical
wiring knowledge or experience, contact a licensed
electrician to complete this repair.
Tools Needed
One Phillips Head Screwdriver
One Stepladder
Turning off wall switch is not sufficient. To avoid possible
electrical shock, be sure electricity is turned off at the
main fuse box before wiring. All wiring must be in
accordance with National and Local codes and the ceiling
fan must be properly grounded as a precaution against
possible electrical shock.
WARNING
!
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
WARNING
!