Operation (Figure 3)
Your remote control has full control of your
fan and light.
NOTE: Prior to operation of the fan and
light from the remote control, set the fan
speed to HIGH (
....
) and turn the light ON
( ).
1.
To set the desired fan speed, press one of
the four buttons (
.
,
..
,
...
,
....
) to operate
your fan from low to high speeds.
2.
To turn the downlight on, press and
release the ( ) button. The light will turn
on at the light intensity previously selected.
3.
To vary the intensity of the light, hold the
( ) button down until the desired light
intensity is reached, then release the
button.
Note:
When turning the light on, light will
turn on at the light intensity previously
selected.
Part No. F40BP74120002
Form No. BP7412-2
Printed in U.S.A. 09/11
CAUTION: Read all instructions carefully before installation.
Save this Owner's Manual for future reference.
Part No. F40BP74120002
Form No. BP7412-2
Fan/Light Fails to Operate
• Check that the speed switch on the fan
is set to HIGH (
....
) speed.
• Check that the light switch is on.
• Check that the battery is good
(power indicator light should light when
any button is pressed).
• Check that the receiver is wired
properly.
• Check that code switches in the remote
control and receiver are set in the same
position.
Short Range
• If the remote control operates the fan
when close to it, but does not operate
it at a distance of 40 feet, try placing
the antenna wire outside of the ceiling
cover.
Trouble Shooting
IMPORTANT
Fan installation must be completed,
including the installation of the fan
blades, before testing the remote
control.
HIGH TO LOW
BUTTONS
POWER
INDICATOR
LIGHT
LIGHT
BUTTON
FAN
BUTTON
STORAGE
BRACKET
TO INSTALL
BRACKET TO WALL:
SLIDE THE COVER UP
TO EXPOSE THE
SCREW HOLES FOR
INSTALLATION
COVER
SCREW
HOLES (2)
WALL
BRACKET
Figure 3
Installation of Storage
Bracket
A storage bracket is provided for holding your
remote control when not in use. If you desire
to use the bracket, install it on a wall that is
away from excess heat or humidity.
Air Comfort Products
DIVISION OF EMERSON COMPANY
8100 W. Florissant • St. Louis, MO 63136
Ceiling Fan/Light
Remote Control Owner's Manual
Model Number
SR400
• 4-Speed Hand Held
Transmitter
• Single Light
• Supplied with
Receiver
• Includes Light
Dimming Selection
Switch
Model Number
SR401
• 4-Speed Hand Held
Transmitter
• Single Light
• Use with SR400 or
SW405
• Includes Light
Dimming Selection
Switch
Safety Instructions
WARNING:
To avoid fire, shock, and serious personal injury, follow all instructions
carefully.
1. Read your Owner's Manual carefully before installing the remote control. Retain
Owner's Manual for future reference.
2. Be careful of the fan and blades when installing the receiver in the ceiling cover.
Before installing or servicing the ceiling fan or receiver, switch power off at service
panel and lock service panel disconnecting means to prevent power from being
switched on accidentally. When the service disconnecting means cannot be locked,
securely fasten a warning device, such as a tag, to the service panel.
ADDITIONAL SAFETY INSTRUCTIONS FOR INSTALLATION
1. To avoid possible electrical shock, be sure electricity is turned off at the main fuse or
circuit breaker box before wiring.
2. Make certain no bare wires are exposed outside the wire connectors.
3. All wiring must conform to National and Local Electrical Codes.
4. Follow the recommended instructions for the proper method of wiring your new remote
control. If you feel you do not have enough electrical wiring knowledge or experience,
have your remote control installed by a licensed electrician. Any electrical work not
described in this manual should be performed by a licensed electrician.
WARNING
!
