6
U.L. Model No.: CF4900
3. Ceiling Fan Assembly
(continued)
DOWNROD
PIN
SETSCREW
HANGER BALL
Figure 4
3.4
Remove the hanger ball by loosening the setscrew in
the hanger ball until the ball falls freely down the
downrod (Figure 4).
Remove the pin from the downrod, then remove the
hanger ball. Retain the pin and hanger ball for
reinstallation in Step 3.10.
SETSCREW
CLEVIS PIN
MOTOR
COUPLING
DOWNROD
HAIRPIN
CLIP
HAIRPIN
CLIP
MOTOR
COUPLING
SETSCREW (2)
CLEVIS PIN
DOWNROD
Figure 5
It is critical that the clevis pin in the motor coupling is
properly installed and the setscrews securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
WARNING
!
3.5
Separate, untwist and unkink the three 80” motor leads.
Route the motor lead wires through the downrod.
Align the clevis pin holes in the downrod with the holes
in the motor coupling. Install the clevis pin and secure
with the hairpin clip (Figure 5).
The clevis pin must go through the holes in the motor
coupling and the holes in the downrod. Be sure to push
the straight leg of the hairpin clip through the hole near
the end of the clevis pin until the curved portion of the
hairpin clip snaps around the clevis pin.
The hairpin clip must be properly installed to prevent the
clevis pin from working loose. Pull on the downrod to
make sure the clevis pin is properly installed.
SETSCREW (1)
5/32"
SETSCREW
WRENCH
MOTOR
COUPLING
Figure 6
3.6
Insert the setscrew (supplied in loose parts bag) into the
motor coupler hole until it rest against the downrod.
Securely tighten the setscrew using the 5/32" setscrew
wrench (provided).
Pull up on the downrod to make sure the setscrew is
firmly installed against the motor coupler (Figure 6).
NOTE: The setscrew must be properly installed as
described above, or fan wobble could result.
BP7485 Southtowne CF4900 12/4/13 10:15 AM Page 6