Emerson SH Series, Руководство по установке

Страница: 13 / 17

Installation Instructions
SH/Install/2016-09 Rev. 1 September 2016
10
Section 3: Step by Step Installation on Valve
Step by Step Installation on Valve
Figure 12 Mounting the Actuator to the Adapter
Adapter
Angle Bearing
4. Remove the 3/8” socket head cap screws and banana washers. Lift the actuator
off the adapter, see illustration at the top. Now turn the bracket to line up the bolt
holes and install the 3/8” hex head cap screws, lockwashers and nuts.
Loosen the adjusting screws to allow them to pass angle bearing and lower the
actuator back onto the adapter. Use care aligning the spline in the adapter with
the one on the actuator.
Replace the 3/8” socket head cap screws and banana washers and tighten. Tighten
the hex head cap screws and nuts. Tighten the adjusting screws against the angle
bearing.