25
emersonfans.com
Please contact 1-800-654-3545 for further assistance
U.L. Model No.: CF605
7. Remote Control Procedures
(Continued)
7.8: Storage Bracket Installation
Install the two Screws (provided with bracket) into the
Wall Bracket and tighten to secure to Wall (Figure 40).
Slide the Wall Bracket Cover back down over the
screws.
TO INSTALL BRACKET
TO WALL:
INSTALL THE TWO SCREWS
SLIDE THE COVER DOWN
WALL
BRACKET
SCREWS (2)
COVER
Figure 40
7.6
The Light ( ) Push Button turns the light on and off
and controls the light intensity (Figure 38).
To vary the intensity of the light, hold the
(
) Button down until the desired light intensity is
reached, then release the button (Figure 38).
NOTE: When turning the light on, light will turn on
at the light intensity previously selected.
Your Remote Control has full control of your fan and
light.
The Power Indicator Light (blue glow) will illuminate
while any button is pressed, indicating that the Battery
is good.
HIGH TO LOW
BUTTONS
POWER INDICATOR
LIGHT
LIGHT BUTTON
Figure 38
7.7: Storage Bracket Installation
A Storage Bracket is provided for holding your Remote
Control when not in use. If you desire to use the
Bracket, install it on a wall that is away from excess
heat or humidity.
Slide the Wall Bracket Cover up to expose the screw
holes for installation (Figure 39).
Position the Bracket on the wall in desired location.
TO INSTALL BRACKET TO
WALL:
SLIDE THE COVER UP TO
EXPOSE THE SCREW
HOLES FOR INSTALLATION
COVER
WALL
BRACKET
SCREW
HOLES (2)
Figure 39
