Emerson PACMotion IC830DP 01207, Руководство по аксессуарам

Страница: 12 / 36

PACMotion™ Servos Accessories Guide Section 3
GFK-3173C December 2020
Shielding Accessories 6
3.4 External Shielding Busbar (purchased separately)
In special cases, the cable shields can be routed to an additional busbar via shield clamps. The following
shield clamp is recommended:
Figure 7: External Shield Busbar
A possible scenario for setting up a busbar for the above shield clamps is described below.
1. Cut a busbar of the required length from a brass rail (cross-section 10 x 3 mm) and drill holes in it as
indicated. All shield clamps required must fit between the drill holes.
Figure 8: Cutting the Busbar
2. Squeeze together the coil spring and the supporting plate and push the busbar through the opening in
the holder.
CAUTION
Risk of injury is present due to the spring force of the coil spring. Use pincers.
3. Mount the busbar with the shield clamps fitted on the assembly plate. Use either metal spacer bushes
or screws with nuts and accessories to maintain a spacing of 50 mm. Earth the busbar using a single
conductor with a cross-section of at least 2.5 mm².