5
11. Remove the three switch housing mounting
screws (Figure 4) from the switch housing plate.
Position the switch housing assembly on the
switch housing plate and align the holes in the
switch housing assembly with the holes in the
plate. Secure the switch housing assembly by
installing the three mounting screws (Figure 5).
NOTE: Do not pinch wires between the switch
housing assembly and the switch housing plate.
12. You have now completed the assembly of your
new ceiling fan. You can now proceed with hang-
ing and wiring your fan.
MOUNTING SCREWS (3)
SWITCH
HOUSING
ASSEMBLY
Figure 5
SWITCH
HOUSING
ASSEMBLY
SWITCH HOUSING
CONNECTOR
MOTOR CONNECTOR
Figure 4
Electrical Requirements
If your fan is to replace an existing ceiling light fixture,
turn electricity off at the main fuse box at this time and
remove the existing light fixture.
Your new ceiling fan will require a grounded electrical
supply line of 120 volts AC, 60 Hz, 15 amp circuit.
The outlet box must be securely anchored and capa-
ble of withstanding a load of at least 50 pounds.
1. Securely attach the hanger bracket to the outlet
box using the two screws supplied with the outlet
box. (Figure 7.)
How to Hang Your
Ceiling Fan
AT LEAST
7'
CEILING
FLOOR
Figure 6
TWO SCREWS
SUPPLIED WITH
OUTLET BOX
HANGER
BRACKET
TAB
OUTLET
BOX
Figure 2
Figure 7
To reduce the risk of fire, electric shock, or personal injury,
mount fan to outlet box marked acceptable for fan support,
and use screws supplied with outlet box. Most outlet boxes
commonly used for support of light fixtures are not accept-
able for fan support and may need to be replaced. Consult a
qualified electrician if in doubt.
WARNING
!
Turning off wall switch is not sufficient. To avoid possible
electrical shock, be sure electricity is turned off at the main
fuse box before wiring. All wiring must be in accordance
with National and Local codes and the ceiling fan must be
properly grounded as a precaution against possible electri-
cal shock.
WARNING
!
The fan must be hung with at least 7' of clearance from
floor to blades (Figure 6).
Hanger bracket must seat firmly against outlet box. If the
outlet box is recessed, remove wall board until bracket con-
tacts box. If bracket and/or outlet box are not securely
attached, the fan could wobble or fall.
To reduce the risk of fire, electric shock, or personal injury,
mount fan to outlet box marked acceptable for fan support,
and use screws supplied with outlet box. Most outlet boxes
commonly used for support of light fixtures are not accept-
able for fan support and may need to be replaced. Consult a
qualified electrician in in doubt.
To avoid fire or shock, follow all wiring instructions carefully.
Any electrical work not described in these instructions
should be done or approved by a licensed electrician.
The outlet box must be securely anchored and capable of with-
standing a load of at least 50 lbs.
WARNING
!
WARNING
!
WARNING
!
WARNING
!
WARNING
!
