2
Safety Instructions
WARNING:
To avoid fire, shock, and serious personal injury, follow all instructions carefully.
1.Read your Owner's Manual carefully before installing the light fixture. Retain Owner's Manual for
future reference.
2.Be careful of the fan and blades when cleaning, painting, or working near the fan. Before installing
or servicing the light fixture or ceiling fan, switch power off at service panel and lock service panel
disconnecting means to prevent power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a warning device, such as a tag, to the
service panel.
3.Do not exceed the wattage indicated on fixture.
ADDITIONAL SAFETY INSTRUCTIONS FOR INSTALLATION
1.To avoid possible electrical shock be sure electricity is turned off at the main fuse or circuit breaker
box before wiring.
2.Make certain no bare wires are exposed outside the wire connectors.
3.All wiring must conform to national and local electrical codes.
4.Follow the recommended instructions for the proper method of wiring your new light fixture. If you
feel you do not have enough electrical wiring knowledge or experience, have your light fixture
installed by a licensed electrician. Any electrical work not described in this manual should be
performed by a licensed electrician.
WARNING:
To reduce the risk of possible fire and electrical shock, install only on Emerson CF
Series Ceiling Fans.
Assembly and Installation
4.
Remove the center screw from the switch cup
(Figure 1).
5.
Carefully locate the white and blue wires (labeled
either "L" or "LIGHT") in the switch cup and
remove the wire connectors from the wires.
6.
Insert the black and white wires from the light fitter
through the center hole in the switch cup
(Figure 2) and thread the switch cup onto the light
fitter. Hold wires taut while installing switch cup to
prevent the wires from twisting. Tighten the fitter
until the fan switch chain aligns with the hole in the
fitter.
7. If installing in a wet location:
Install the light
fitter on plate using the lockwasher, nut and
rubber washer supplied with wet location plate.
Place the rubber washer on the top of the wet
location plate, then place the light fitter through the
center hole of the wet location plate, secure with
lockwasher and nut (Figure 2).
Do not install or use the light fixture if any part
is missing or damaged. Contact your dealer for
replacement.
SCREWS
CENTER SCREW
SWITCH
CUP
MOTOR
CONNECTOR
COVER PLATE
SWITCH CUP
CONNECTOR
Figure 1
Installation on Emerson Fans
Having a Modular Switch Cup with
Center Screw
1.
Remove all parts and parts packages from the
carton.
2.
Remove the switch cup from the cover plate by
removing the three screws around the side of the
switch cup (Figure 1).
3.
Disconnect the motor connector from the switch
cup connector (Figure 1).
WARNING
!
To avoid possible electrical shock, be sure
electricity is turned off at the main fuse or
circuit breaker box before wiring.
WARNING
!
