8
ETL Model No.: LK180LED/LK150LED
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
WARNING
!
4.1
Disconnect electrical power to the branch circuit at the
circuit breaker or fuse box before attempting to install
the light fixture.
FAN
SWITCH
CHAIN
SWITCH
HOUSING
SCREWS (2)
SWITCH
HOUSING
COVER
Figure 12
4. Installation on Emerson Fans Having a
Two-Piece Die-Cast Switch Housing
4.2
Remove the switch housing cover from switch housing
below ceiling fan by unscrewing the two switch housing
cover screws (retain the screws for future use)
(Figure 12).
REMOVE
WIRE
CONNECTOR
WHITE WIRE
BLUE WIRE
SWITCH
HOUSING
REMOVE
WIRE
CONNECTOR
4.3
Carefully pull down white and blue wires from the
switch housing and remove wire connectors
(Figure 13).
Retain wire connectors for future installation.
Figure 13
SWITCH
HOUSING
COVER
LED LIGHT FIXTURE
ASSEMBLY BLACK &
WHITE WIRES
THREADED STUD
LED LIGHT
FIXTURE
ASSEMBLY
DO NOT
TOUCH LED's
HEX NUT AND
LOCKWASHER
4.4
CAUTION:
DO NOT touch the LED’s, located on
the LED light fixture, due to the possibility of static
discharge destroying the assembly.
Remove the hex nut and lockwasher from the top of the
LED light fixture assembly threaded stud (Figure 14).
Retain the hex nut and lockwasher for future
installation.
Pass the white and black wires of the LED light fixture
assembly through the cover and thread the cover onto
the threaded stud. Securely hand tighten the cover.
Pass the white and black wires through the lockwasher
and hex nut, and install on the threaded stud.
Secure the LED light fixture assembly to the cover by
tightening the hex nut using a wrench.(Figure 14).
Figure 14
BP7503 LK150 LK180 10/13/15 3:56 AM Page 8
