8
DOWNROD
80" FAN MOTOR
WIRES (5)
Figure 9
3.9
Separate, untwist and unkink the Five 80” Motor Wires.
Route the Five 80” Motor Wires through the Downrod
(Figure 9).
8
ETL Model No.: CF840
3. Ceiling Fan Assembly
(Continued)
#8-32 x 1/2" WASHER HEAD
BLADE SCREWS
(2 per blade)
Figure 7
3.7
Carefully turn the partially assembled Ceiling Fan right
side up for preparation of remaining assembly.
NOTE: Be Extra Careful of the Unassembled Fan
Blades while turning the Fan Upright.
Secure the Fan Blades at this time. Install and
tighten the remaining #8-32 x 1/2” Washer Head
Blade Screws (supplied), 2 Screws per Blade
(Figure 7).
A spare #8-32 x 1/2” Washer Head Blade Screw is
supplied in the parts bag, if needed.
PHILLIPS HEAD SET SCREW
(LOOSENED)
HANGER BALL
4.5" DOWNROD
PIN
GREEN GROUND WIRE
Figure 8
3.8
Remove the Hanger Ball by loosening the Phillips Head
Set Screw in the Hanger Ball until the Ball falls freely
down the 4.5” Downrod (Figure 8).
Remove the Pin from the Downrod, then remove the
Hanger Ball (Figure 8).
Retain the Pin and Hanger Ball for reinstallation in
Step 3.12.
Note: Do not loosen the screw that attaches the
green ground wire to the hanger ball.
