Emerson Fisher FIELDVUE DVC6000f, Инструкция по эксплуатации

Страница: 224 / 384

DVC6000f Digital Valve Controllers
December 2009 4-164
Table 4-79. BLOCK_ERR Conditions
Condition
Number
Condition Name and Description
0 Other (N/A)
1
Block Configuration Error—CHANNEL set to 0 through 10
(uninitialized)
2 Link Configuration Error (N/A)
3
Simulate Active—Simulate is enabled. Output does not
reflect process conditions
4 Local Override (N/A)
5 Device Fault State Set (N/A)
6 Device Needs Maintenance Soon (N/A)
7
Input failure/process variable has Bad status—The
hardware is bad or the transducer block mode is Out of
Service
8 Output Failure (N/A)
9 Memory Failure (N/A)
10 Lost Static Data (N/A)
11 Lost NV Data (N/A)
12 Readback Check Failed (N/A)
13 Device Needs Maintenance Now (N/A)
14
Power Up—Set after power-up until actual mode is not Out of
Service
15
Out of Service—The actual mode is Out of Service (OOS).
The block is not being processed.
Block Errors
Table 4-79 lists conditions reported in the
BLOCK_ERR [6] parameter. Conditions in italics are
not applicable for the DI block and are provided only
for your reference.
Action on Failure
In case of hardware failure, FIELD_VAL_D [17], PV_D
[7], and OUT_D [8] change to a Bad status and the
BLOCK_ ERR [6] parameter shows Process Variable
has Bad Status. If the transducer block mode is Out of
Service, the status of FIELD_VAL_D [17], PV_D [7],
and OUT_D [8] is set to Bad:Out of Service.
Simulation
To support testing of the control strategy, you can
enable the SIMULATE_D [9] parameter. Normally the
measurement value and status used for
FIELD_VAL_D [17] in the DI block reflect actual
process values as provided by the transducer block.
When the SIMULATE_D [9] parameter is enabled,
value and status used for FIELD_VAL_D [17] is
supplied by the user manually. To enable simulation in
the DI function block, the simulate jumper must be
Figure 4-33. Proximity Discrete Input Compared to a
Standard Discrete Input
Configurable
Band
DISCRETE INPUT
VALUE
0
0
1
0
1
STANDARD DISCRETE INPUT
PROXIMITY DISCRETE INPUT
DISCRETE INPUT
VALUE
installed. For information on the installation of this
jumper, see the Installation section.
The SIMULATE_D [9] parameter has three
components:
Simulate_D enable/disable determines whether
the function block will use the actual process value
and status, or Simulate Value and Simulate Status.
Transducer Value and Status reflect the process
values provided by the transducer block.
Simulate Value and Status may be entered by
the user when enable/disable is set to enabled.
To use simulate, first install the simulate jumper in the
terminal box, then set Simulate_D enable/disable to
enabled, then enter the desired values for Simulate
Value and Status.
4