ES-805 Series In-Line Vent Valve
1.
Unbolt and remove the flanges from the body.
2.
Slide the flange onto the receiving pipe. Then slide the
slip-on gasket onto the pipe. The tapered section of the
gasket points away from the flange and towards the
valve. Repeat on the other pipe using the second flange.
3.
Reinstall the flange bolts and nuts, one on each side.
Tighten bolts until flanges are flushed against the body.
4. Install the pallet assembly. The center rib of the pallet
should be in-line with the rib on the body. Then close the
lid and hand tighten the wing-nuts on both sides. Tools
are not to be used to tighten wing-nuts. Check for proper
alignment between the lid and pallet stem. If the pallet is
not installed correctly, the lid would not close.
ES-905 Series End-of-Line Vent Valve
1.
Unbolt and remove the flanges from the body.
2.
Slide the flange onto the receiving pipe. Then slide the
slip-on gasket onto the pipe. The tapered section of the
gasket points away from the flange and towards the
valve (up).
3.
Reinstall the flange bolts and nuts, one on each side of
the flange. Tighten bolts until flange is flushed against
the body.
4
ES-805 and ES-905 Series
North America
Only
