Emerson DIXELL XWEB1000D PRO, Инструкции по установке и эксплуатации

Страница: 7 / 20

1592010820 XWEB5000 PRO STP GB r1.0 18.03.2022.docx XWEB5000 PRO 7/20
5. INSTALLATION
5.1 XWEB
For installation, the XWEB system must not be opened in any way. If the box is opened, the warranty will
lapse.
XWEB can be installed in various ways based on the type of user interface access that you wish to provide
for the final user. Below is a description of the most complete procedure, i.e. where the system's user
interface can be used entirely in local control. If the system has already been configured and you wish to use
the interface through modem or Ethernet, points 5 to 9 may be optional. The particular features of these
types of connectivity are described herein.
To set up a local installation of the system, we recommend having the following equipment available:
•
a Phillips and a slot-head screwdriver;
•
a PS2 or USB mouse;
•
a PS2 or USB keyboard;
•
a monitor with a DVI or VGA connector. We recommend using high
definition monitors
The system must be installed referring to the figure below, which
illustrates the rear XWEB panel, and following the points listed here:
1. The product has a power plug with protective earth. Make sure that
the electrical system has a protective earth connection;
2. Attach the XWEB device in the position it will be used in. If it is
installed on a table, set the rubber feet up in the holes on the
underside of the device. For rack installation, on the other hand, use
the supplied brackets and screws.
3. Connect it to the power mains by the supplied power cord. Set the
power plug up so that it is easily accessible at all times . Note: Do
not turn the system on;
4. Connect the RS485, the relays and digital inputs, and end and/or
polarise the line, if necessary;
5. Connect any telephone lines and/or LAN network cables;
6. Connect any keyboard and mouse;
7. Connect any monitors;
8. Connect any printers;
9. Connect any modem: internal modem or external modems. The
cable must not be any longer than 10 m.
10. It is now possible to turn the system on by pressing and releasing;
For operator safety and to
protect the XWEB
system, before
performing any sort of
operation, connect the
system to the electrical
network by the supplied
cable. Power cord must
be the last to be removed.
•
Avoid direct passage between
operators as much as possible
(to avoid electrostatic induction
and subsequent discharges);
•
If the electrical voltage supply
differs from the required rating,
this could seriously damage the
system;
•
Connection errors (and
connections that differ from the
prescribed ones) can pose a
danger to operator safety and
cause faults in the system and
to the instruments that are
connected to it;
•
Insert one or more easily
accessible
disconnecting
devices to the exterior of the
device to separate the device
from the power mains;
•
Do not use the device in
environments with flammable
gases.
•
Do not modify the device in any
way.