Emerson DIXELL XWEB1000D PRO, Инструкции по установке и эксплуатации

Страница: 12 / 20

1592010820 XWEB5000 PRO STP GB r1.0 18.03.2022.docx XWEB5000 PRO 12/20
6. LOCAL CONNECTIVITY
Local access with a screen, mouse and keyboard directly connected to the XWEB is the most common and
most frequently used type of access for the user interface. The system can work even without these
peripherals connected and it is possible, for example, to use this mode only for the initial configuration of the
system; and then disconnect them even permanently if access is provided only from a remote location.
XWEB supports PS / 2 mouse and keyboard or USB mouse and keyboard which can be connected to any
available USB port. The screen that can be connected to XWEB must be of the type with DVI connector (or
VGA using the adapter supplied as an accessory) and have a minimum resolution of 1024x768. We
recommend using a screen with a resolution higher than 1024x768 pixels. Check your display's instruction
manual for supported resolutions.
7. REMOTE CONNECTIVITY
7.1 GENERAL AND MINIMUM REQUIREMENTS
The user or the installer of XWEB can access its user interface, as well as locally with
screen, keyboard and mouse, also through a PC that must be connected and configured
to be able to communicate with the XWEB network. The XWEB Ethernet port that must
be used for remote connectivity must be the LAN port, as shown in the image below.
Attention : due to its technical characteristics and to maintaining the
quality of the electrical signal, it is recommended to use shielded
ethernet cables; if it is not possible to use shielded cables, apply the
supplied ferrites; the image below shows the ferrite applied to a LAN
port.
Performances using a PC as a user interface terminal is greater than the use of local connectivity,
therefore it is recommended to use it especially in the first configuration phase. The user interface available
remotely is the same as available locally.