20
C6.1.6/0117-1017/E
2.10.3 Single commands
Press the SET button to display the target setpoint. In programming mode, this
allows to select a parameter or to confirm an operation.
Press the RESET button and hold for 5 seconds to reset any lockouts if the
current state of the controller allows for it to be reset.
(UP)
To view the fast access menu. In programming mode, this browses the
parameter codes or increases the displayed value.
(DOWN)
In programming mode, this browses the parameter codes or decreases
the displayed value.
(SERVICE)
To enter the service and alarm menu.
Hold for 3 seconds to start a manual defrost or terminate an active defrost.
Table 16: Single commands
2.10.4 Double commands
– Entering programming level 1 "Pr1"
Press simultaneously for about 3 seconds to lock (
PoF
) or unlock (
Pon
) the
keyboard.
Press simultaneously to leave the programming mode or menu. On submenus
rtC
and
EEV
this combination allows to go back to the previous level.
Press simultaneously for about 3 seconds to access the first level of
programming mode.
Table 17: Double commands
The device provides 2 programming levels:
▪
Pr1
with direct access
▪
Pr2
protected with a password (intended for experts)
2.10.5 How to program the parameters (Pr1 and Pr2)
Access pre-
program level
Press simultaneously for about 3 seconds to access the pre-
programming level. The message
rtC
(real time clock) appears.
Access
program level
or
Press the
Up
or
Down
key until the message
Par
appears.
Access Pr1
Press the
SET
button to enter the program level. First parameter
C01
appears.
Select item
or
Select the parameter or submenu using the arrows.
Show value
Press the
SET
button.
Modify
or
Use the arrows to modify the value.
Confirm and
store
Press the
SET
button: the value will blink for 3 seconds, then the
display will show the next parameter.
EXIT
Press simultaneously to exit the programming mode, or wait
for 30 seconds (MTO) without pressing any key.
Table 18: Programming level 1 parameters
When entering the programming level for the first time the display will show the
rtC
(real time clock)
label.
▪
Press
to access parameters N01/02/03/04/05 to adjust time & date. For further details,
see Chapter 2.12, "Parameters level 1
– Required settings".
▪
Press
or
to change from the
rtC
label to the
Par
label, in order to access the
programming level 1.
▪
Press
: the parameters of programming level 1 can be changed.
Содержание Copeland EazyCool ZX Series
Страница 1: ...Copeland EazyCool Outdoor Condensing Units ZX Range Application Guidelines ...
Страница 5: ......
Страница 11: ...6 C6 1 6 0117 1017 E Figure 2 ZX unit housing ...
