4
1.
Rotate the motor hub to align the hub notch area
over each of the five screws which is holding the
shipping retainer to the motor assembly. One by
one unscrew each screw and discard screw and
shipping retainer (Figure 1).
BLADE FLANGE
M5 x 12mm WASHER
HEAD BLADE SCREW
(4 per blade/flange)
FAN BLADE
FLAT WASHER 16 mm OD
(4 per blade/flange)
To reduce the risk of personal injury, do not bend the
blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not
insert foreign objects in between rotating fan blades.
WARNING
!
Figure 2
MOTOR HUB
NO
TE
! R
em
ov
e R
ub
be
r P
ack
ing
Moun
ts And
Di
sc
ar
d
Be
fo
re
Ins
tal
lati
on.
NO
TA
! Q
uit
ar
Lo
s S
op
ort
es D
e Go
ma Pa
ra
Em
ba
la
Je
Y
Ti
rar
Lo
s A
nte
s D
e La
Insta
lacion.
REMOVE SHIPPING RETAINER
BY REMOVING 5 SCREWS
Figure 1
2.
Mount blade flanges (supplied with fan) to fan
blades (sold separately) using four M5 x 12mm
washer head blade screws and four 16mm flat
washers (supplied with fan) (Figure 2).
NOTE: Some accessory blades available are
supplied with shorter screws. These shorter
screws MUST be used to assemble the blades to
flanges.
3.
Loosely attach one blade/flange assembly to the
motor hub by securing the two M6 x 14mm captive
pan head screws. Make sure the screws are NOT
tightened (Figure 3). Repeat this procedure for
other four blade assemblies.
How to Put Your Ceiling Fan Together
Electrical Requirements
If your fan is to replace an existing ceiling light fixture,
turn electricity off at the main fuse box at this time and
remove the existing light fixture.
Your new ceiling fan will require a grounded electrical
supply line of 120 volts AC, 60 Hz, 15 amp circuit.
The outlet box must be securely anchored and
capable of withstanding a load of at least 50 pounds.
To avoid fire or shock, follow all wiring instructions
carefully. Any electrical work not described in these
instructions should be done or approved by a
licensed electrician.
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring. All
wiring must be in accordance with National and
Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
WARNING
!
WARNING
!
To reduce the risk of fire, electrical shock, or
personal injury, mount fan to outlet box marked
“Acceptable for Fan Support of 50 lbs or less”, and
use screws supplied with outlet box. Most outlet
boxes commonly used for support of light fixtures
are not acceptable for fan support and may need to
be replaced. Consult a qualified electrician if
in doubt.
WARNING
!
U.L. Model No.: CF787
NOTE: Take care not to scratch fan housing when
installing blades.
