8. Install the setscrew (supplied) in the motor coupling
and tighten using the 5/32” setscrew wrench
(supplied) (Figure 3B).
9. Screw two 1” threaded studs (provided) into the
motor (Figure 4B). Leave approximately 7/8” of the
stud extending above the motor. Coil the wires and
wire connectors around the motor coupling, then
slide the motor cover over the downrod and rotate
the cover until the threaded studs protrude. Install
two lockwashers (supplied) and knurled knobs
(supplied) to secure the cover to the motor. All
wires and wire connectors must be enclosed under
the motor cover.
NOTE: Lightly snug the knurled knob and make
sure the wires and wire connectors are completely
inside the motor coupling cover and not pinched
between the motor coupling cover and the motor.
1. Position the motor housing and shade assembly in
the foam packing so that the top for the motor is
facing you.
2. Obtain the hanger ball/downrod assembly and
remove the hanger ball by loosening the setscrew
in the hanger ball until the ball falls freely down the
downrod (Figure 1B). Remove the pin from the
downrod, then remove the hanger ball. Retain the
pin and hanger ball for reinstallation in Step 9.
Discard 4-1/2” downrod if using 18” or longer
downrod.
3. Push the yellow uplight lead connector through the
downrod (Figure 2B) until it extends about 6”.
4. Cut the yellow lead approximately 3” from the end
of the downrod (Figure 2B). Strip insulation 1/2”
from end of wire.
5. Separate, untwist and unkink the three black, white
and blue motor wires, then route the wires through
the downrod.
6. Using wiring connectors (supplied), connect the
yellow uplight lead to the yellow wire from the
downrod (Figure 3B). Fold the yellow wire into the
slot in the motor coupling, slide the downrod down
the wires and seat the downrod in the motor
coupling.
7. Align the clevis pin holes in the downrod with the
holes in the motor coupling. Install the clevis pin
and secure with the hairpin clip (Figure 3B). The
clevis pin must go through the holes in the motor
coupling and the holes in the downrod. Push the
straight leg of the hairpin clip through the hole near
the end of the clevis pin until the curved portion of
the hairpin clip snaps around the clevis pin. The
hairpin clip must be properly installed to prevent
the clevis pin from working loose.
10
SECTION B
Assembly Instructions for Installing the CF2600 and CF2650
Ceiling Fan Controlled by Emerson Fan/Light Controls
(other than SR330 or SW350) or Standard Wall Switches
HANGER BALL
PIN
DOWNROD
SETSCREW
Figure 1B
7/8"
1" THREADED STUD
MOTOR COVER
KNURLED KNOB
LOCKWASHER
MOTOR
Figure 4B
DOWNROD
MOTOR COUPLING
CLEVIS
PIN
HAIRPIN
CLIP
CONNECT YELLOW
WIRES USING WIRE
CONNECTOR
SETSCREW
SETSCREW
CLEVIS PIN
MOTOR
COUPLING
DOWNROD
HAIRPIN
CLIP
Figure 3B
3"
DOWNROD
CUT HERE
YELLOW UPLIGHT
LEAD
6"
CEILING
END
4-1/2" OR 18"
MOTOR
END
Figure 2B
It is critical that the clevis pin in the motor coupling
is properly installed and the setscrew securely
tightened. Failure to verify that the pin and setscrew
are properly installed could result in the fan falling.
WARNING
!
