emerio WH-125971, Инструкция по эксплуатации

Страница: 8 / 86

- 7 -
Heating selection Press it consecutively, you will make the appliance runs in low heating,
high heating and no heating (Only the fan is working.).
Timer setting Press the button once or several times to set the timer from 1H to 8H (“H”
stands for hour.). For example, when you set it as 3H, the appliance will
automatically enter into standby after 3 hours.
Swing selection Press it to turn on or off the swing function. When the swing is on, the
cover on the air outlet will swing slowly.
Temperature setting Press it to
enter the temperature setting. Press buttons “+” “ - ” to select
the desired temperature. The set temperature will flicker for several
seconds and then the setting is completed, the LED will go back to the
display of room temperature. The temperature range you can select is
from 18
℃
to 45
℃
.
Open window
detection
Press this button to turn on or off the open window detection, which
cannot be start up when the appliance is in no-heating mode or
temperature setting.
Week timer Press this button to select the desired week timer mode, P1 – P5 are
system settings, and P6 is free mode.
Cancel button for
temperature setting
mode and week
timer During the setting, directly press this button to cancel the setting.
After the setting is completed, first press the temperature setting button
(if you want to cancel the temperature setting) or the week timer button
(if you want to cancel the week timer), then press this button.
Value increase Press this button to increase the value when needed.
Value decrease Press this button to decrease the value when needed.
Confirmation Press this button to confirm the value just set.
WALL MOUNTING
This heater has been designed to hang securely on the wall. Do not use it until it has been properly installed,
as described in these instructions for use and never, for example, in a standing position or when leaning
against something!
Two expansion bolts are provided for the wall mounting. See below drawings and follow the instructions. After
the mounting, the distance between the product and ceiling / side walls should be at least 30 cm.
1.
Drill two holes in a wall. The holes should be above 2 meters from the ground. The diameter of the holes
should be just containing the expansion bolt, which is 6 mm. The distance between the hole centers should
be 315 mm.
2. Tuck the expansion bolts into the holes. The inside bolts should protrude about 10 mm than the expansion
pipes to form the pothooks.
3. To hang on the appliance, align the pothook with the spot A, then move and make the pothook stay at the
spot B
(arrow ①).
To remove the appliance, align the pothook from the spot B back to the spot A (arrow ②), then take off
the appliance.