Emcotec RC Electronic DPSI BMS, Руководство по эксплуатации

Страница: 10 / 32

DPSI BMS Operating Manual Version 1.0
Page 10 of 32
6. Mounting Instructions
6.1. Mounting of the DPSI BMS
The DPSI BMS is designed as a cockpit instrument and therefore can
be mounted as such (especially interesting for scale models). Of
course, mounting on a small board inside the fuselage is also possible.
The mounting place should not be exposed to extreme vibrations (as is
the case at a fuselage’s side wall without a strengthening frame). The
DPSI BMS is solid mounted by the accompanying frame which serves
as a counter bearing. By the way, the frame can serve as a positioning
device for the cutout of the DPSI BMS.
The screwing connection is accomplished with the delivered M3
screws and stop nuts, which do not get loose even when exposed to
vibrations.
Dimensions for mounting:
After mounting, the connector cables can be put into their
corresponding plugs/sockets. In order to avoid loosening of the
connections caused by vibrations, the accompanied bracket is fed in
between the positive and negative pole of the connection cable and
locked at the sides of the housing of the DPSI BMS. Herewith, the
connectors are secured against vibrating loose.