Emcotec Locating Beeper, Руководство по эксплуатации

Страница: 13 / 20

Locating Beeper Operating Instructions Version 1.0
Page 13 of 20
4.2. Deactivating the Alarm Signals
The user can stop the output of an alarm signal if the Locating Beeper
PRO runs autarky (i.e. supplied by its internal battery).
The alarm output beeps for more than 2 hours if not stopped until the
internal battery is empty.
There are deactivating possibilities, depending on the event which
triggered the alarm.
If the alarm was triggered by servo signal monitoring:
•
Deactivation only by a valid servo signal, i.e. turning the
receiver back on. Deactivation of the alarm function is
described in chapter 4.1.
If the alarm was triggered by voltage monitoring (e.g. function of the
tow rope finder):
•
Connect an external supply voltage or
•
Connect minus and servo pulse
If both pins minus (brown) and pulse (orange) of the connection cable
are shorted the error output is stopped after 1 second. Use the
delivered short circuit jumper (see photo).