Emcotec DPSI V-Match, Руководство по эксплуатации

Страница: 4 / 16

DPSI V-Match Operating Instructions Version 1.0
Page 4 of 16
1. Functionality
DPSI V-Match constitutes a servo V-cable
that accommodates two commercially
available servos.
As a special feature, one servo (SLAVE) is
programmable for direction, as well as
center position and end-limits. Therefore,
this servo adapts ("matches") to the main
servo (MSTR).
This is especially handy if two servos actuate on one rudder (e.g. two
servos on one aileron) and synchronism cannot be established by
mechanically means. Often, it suffices if one servo's direction can be
changed (e.g. counter rotating mounted servos for the airplane's
elevator). This too, is simply accomplished with DPSI V-Match.
Failsafe-Function:
A failsafe-function is added to its features. Both servos (MSTR and
SLAVE) remain at their current position (HOLD) when encountering an
erroneous or missing receiver signal until a valid signal is again
delivered by the receiver. A flashing red LED (at the PCB's side)
indicates this state and stays active (i.e. flashes) until power is turned
off.
Powerful Servos:
The electronically design of the DPSI V-Match allows for usage of
powerful digital servos; supply voltage ranging up to 8.4 volts. Due to
the PCB (4-layer) and the thick (0.34 mm
2
) connection cable, current
load is especially high.