Component description
EMC VNX VG2/VG8 Hardware Information Guide
23
Figure 18 Management module
Management module Ethernet (RJ-45) NIC ports
The VNX VG2/VG8 management module comes with three integrated dual-port Ethernet
ports (labeled 0, 1, and 2) on the rear of the management module. These ports provide an
interface for connecting to 10-Mb/s, 100-Mb/s, or 1000-Mb/s networks and provide
full-duplex (FDX) capability, which enables simultaneous transmission and reception of
data.
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to
telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports
contain TNV circuits. Some LAN and WAN ports both use RJ-45 connectors. Use caution
when connecting cables.
To access the Ethernet ports, connect a Category 3, 4, 5, 5E, or 6 unshielded twisted-pair
(UTP) cable to the RJ-45 connector on the back of the management module, as described
in
.
1
Power/fault LED
5
NMI
1
reset button
1. NMI = Non-maskable interrupt. When pressed, it clears the processor so that the software can continue to
execute.
2
Management module push button latch
handle
6
DB-9 serial console socket connector
3
RJ-45 Ethernet NIC port (labeled 1)
7
RJ-45 Ethernet NIC port (labeled 0)
4
Data Mover enclosure ID numeric display
8
RJ-45 Ethernet NIC port (labeled 2)
2
0
1
#
1
2
3
4
5
6
7
8
CNS-001754