NOTE:
Refer to the NVRAM Battery Charging Instructions for information on battery
charge time at initial system installation.
Log into the system with the user name of sysadmin. The password is the
system’s serial number. At the first login, the CLI configuration utility starts.
4
You will be prompted to enter the Name, and Domain Name of the system
4
You will next be prompted to configure the initial IP port. You can choose
DHCP or enter a static IP address and Net Mask.
4
You will then be asked to either exit the configuration utility and continue
configuring the system using the Graphical User Interface, or to continue
using the CLI configuration utility
Both the CLI configuration utility and GUI configuration wizard contain six
sections: Licenses, Network, File System, System, CIFS, and NFS. The GUI also
includes a section to configure VTL.
uSinG tHE cli conFiGuration utility
The list entries in the utility can be comma-separated, space-separated,
or both.
4
At each prompt, enter a value, OR
4
Enter a question mark (?) for more details, OR
4
Press Enter to accept the value displayed in braces.
Follow the configuration utility instructions for entering appropriate values.
At the end of each configuration section, you can choose to: Save, Cancel, or
Retry (restart the input entry as the beginning of the current section).
Perform initial System configuration
3
SyStEM SEtuP WorkSHEEt
An installation requires information unique to your site. Before starting the
installation, provide values for the system information listed below.
1.
A fully qualified host name for the system:
2.
The DNS domain name:
3.
Use Table 1 (below) to enter Ethernet connectivity information.
4.
A default gateway IP address (if no DHCP):
5.
DNS server IP addresses (if no DHCP) (fill in below):
Primary
Secondary
Tertiary
6.
Select the CIFS authentication method:
Workgroup
❑
Active Directory
❑
Workgroup name:
Realm name:
Backup user
name:
Domain admin
name:
Password:
Password:
7.
Host name from which to administer the system:
8.
Administrator’s email address (or admin group alias):
9.
(Optional) Description of the system’s physical location:
10.
Mail server (SMTP) host name:
11.
Time zone name (default is US/Pacific):
12.
System Controller ID from the License Code document provided in
the accessory kit. Use this ID to obtain the unique WWPN for this
controller using the WWPN tool at
https://my.datadomain.com/US/en/wwpn.jsp
13.
Record the serial number (SN) found on the back of the chassis,
center right edge.
14.
Record all license keys from the license code document provided in
the accessory kit.
Define the Data Domain System information for your Site
2
Ethernet Connectivity
ethMa
eth0x
eth1x
eth2x
eth3x
eth4x
eth5x
Enable
eth0a
eth1a
eth2a
eth3a
eth4a
eth5a
Enable
eth0b
eth1b
eth2b
eth3b
eth4b
eth5b
Enable
eth0c
eth1c
eth2c
eth3c
eth4c
eth5c
Enable
eth0d
eth1d
eth2d
eth3d
eth4d
eth5d
Use DHCP*
❑
❑
❑
❑
❑
❑
❑
IP address (if no DHCP)
Netmask (if no DHCP)
*
DHCP is not recommended for production systems
tablE 1:
