Embertec ECEUAV, Руководство пользователя

Страница: 14 / 24

14
The infrared EmberSensor activates the
Power Saving socket, monitors activity
and is also used to set the timing.
Setting your EmberSensor
The included EmberSensor receives
signals from any of your remote controls
and as such recognises when you are
interacting with your Audio Visual (AV)
components.
Your EmberSensor comes already
programmed with a 60 minute
default setting. This setting can be
changed according to your needs,
ranging from 1, 2 or 3 hours, or de-
activated (this may be appropriate
for longer movies or programs where
remote control activity is unlikely).
Using your EmberSensor
NOTE: To enter the Setting Mode,
ensure that your Audio Visual (AV)
equipment is switched on or is in
standby mode.
Press and hold down the button on the
EmberSensor firmly for at least 3 seconds,
then release. The LED light on the
EmberSensor will flash for a few seconds
whilst it enters Setting Mode.
As soon as the LED light on the
EmberSensor has stopped flashing,
immediately begin to set the active
power down to 2 hours, 3 hours
or completely de-activated (not
recommended), by pressing and
releasing the EmberSensor button, as per
the table below.
To set the active power
down timer to:
Press the button on the
EmberSensor slowly,
firmly and deliberately:
To confirm the setting,
the LED light on the
EmberSensor will flash:
1 hour (default setting)
2 hours
3 hours
Cancel
Once (one second),
then release
Twice (one second each),
then release
Three times (one second
each), then release
Five times (one second
each), then release
1 time
2 times
3 times
5 times