EPSILON5 MKII Programmer - User Guide V1.12 – 1
st
August 2007
vi
Ele c t rom a gne t ic Com pat ibilit y (EM C)
Com plia nc e
The
‘EPSILON5’
is a CE Approved Product. It is designed for use in an ESD controlled environment
i.e. development or production. This means, therefore, that the user must ensure that there is no
possibility of damage from electrostatic discharge (ESD). Since the devices and equipment to which
this product is likely to be connected may well themselves be susceptible to ESD, this should not
pose any difficulty.
For example, if you are handling microcontrollers and EEPROMS etc. then you will already be used to
appropriate precautions, such as the use of anti-static mats, wrist straps and so on. You should treat
your
‘EPSILON5’
with the same care as you would these types of devices. Always ensure that you
are not yourself carrying a static charge before handling the product. Wearing an earthed anti-static
wrist strap is recommended.
Equinox have taken great care in designing this product to be compliant with the European EMC
directive. When using the equipment be sure to follow the instructions provided. Although RF
emissions are within prescribed limits, care should be taken if you are using the product near to
sensitive apparatus. If you experience any difficulty please refer to Equinox Technical Support.
RoH S Com plia nc e
The
‘EPSILON5’
is a RoHS compliant product.
ESD Points to remember
•
Work in a static-free environment.
•
Wear an earthed wrist strap when handling either the programmer and/or
any programmable device.
•
Ensure that the PC, programmer and Target system are connected to the
same EARTH (0V) potential.
•
Do NOT plug the ISP cable of the programmer into a Target System when
the Target power is ON.
Warning!
Any damage caused to the programmer by Electrostatic Discharge (ESD) through inadequate
earthing is not covered under the warranty of the product.
