11
Nighthawk Pro 200
yinyanmodel.com
Flight Controller Instruction
Nighthawk Pro 200 flight controller is based on SP Racing F3 ACRO hardware.
For more information, please visit "
http://www.yinyanmodel.com/en/DownList.asp
" to download manual.
Transmitter Joystick Command
Transmitter Joystick Commands (Mode 2 Transmitter used as example)
General Troubleshoot
1
Flight Controller LED Indicators not lighting after connecting to a computer:
-Please check if the computer has the correct Driver installed
-Please check proper voltage is entering the flight controller and Micro USB is compatible
2
Copter LED flashes Green and motors do not arm:
-Please redo Accelerometer Calibration
3
Copter cannot lift off the ground:
-Please check Propeller direction
-Please check Battery voltage
4
Copter arms but one or more motors are not spinning:
-Please check connection between motor and ESC.
5
No Video feed on monitor or goggles:
-Please check Video Transmitter and Receiver connections
-Please check if proper video BAND and CHANNEL are selected
6
RGB Lights are not on:
-Please check LED light power switch is turned ON
-Please check for secure power/signal connections
7
Copter drifts in the Roll and/or Pitch axis:
-Please redo Accelerometer Calibration or use Acc Trim Stick command to tune accelerometer
Appendix
Self Checking Light Status
Red LED and Green LED flashing ->Red LED flashing, Green LED off->Red LED off, Green LED flash couple time
