10
Nighthawk Pro 200
yinyanmodel.com
TO PREVENT THE VIDEO TRANSMITTER FROM BURNING OUT, IT IS
HIGHLY RECOMMENDED TO INSTALL THE VIDEO TRANSMITTER
ANTENNA ONTO THE UNIT BEFORE PLUGGING IN THE MAIN
BATTERY.
Video Transmitter
Video Transmitter channel button is located in the rear of the copter.
1)
Long press 2S to enter BAND selection
2)
Short press to select a BAND (ABCDHL). Long Press 2S to select and continue onto Frequency Channel
selection.
3)
Short press to select a Frequency Channel within the selected band. Long Press 2S to select and exit. (Note:
Video Transmitter automatically times out and saves settings after Frequency Channel selection.
** 25mw/600mw VTx power switch is located on the side of the Video Transmitter. Toggling the switch towards the
front end of the copter is 25mw. Toggling the switch towards the rear end of copter is 600mw. The default power output
is 25mw.
Step 5: Test flight
After completion of initial setup and testing, It is finally time to take flight. Turn on the Radio
Transmitter and connect a 3S-4S LiPo to the copter. Place the Nighthawk Pro 200 in the center of the test
flight field (Safe flying zone). As soon as the Flight controller completes it's initial system startup and
self checking, an LED will indicate solid blue when ready to Arm. **(Before arming motors, please
make sure nothing is around the copter within 5m. (Please refer to Appendix - Self checking light status)
Note:
Radio and Video transmission may be influenced by electromagnetism within your flight area. Please
test the maximum range between your Radio and Video links before actual flight.
ESC Instruction
Nighthawk Pro 200 uses
EMAX
Lightning_S
25A (BLHeli_S) ESCs
.
For more information, please visit "
http://www.yinyanmodel.com/en/DownList.asp
" to download manual.
