2. Key operation instructions
Trim Buttons
When in left-hand mode (left-hand throttle):
1. L1+, L2- are the parameters "+, -" of the throttle [T]
2. L3-, L4+ are the parameters "-, +" of the direction [R]
3. R1+, R2- are the parameters "+, -" of the pitch [E]
4. R3 -, R4+ are the parameters "-, +" of the roll [A]
Mode switching
D8 mode:
press the power switch and the "L1+" button at the same time: turn on and enter
D8 mode, then the mode indicator will turn solid red.
D16 mode:
press the power switch and the "L2-" button at the same time: turn on and
enter D16 mode, then the mode indicator light will turn solid green.
D16 LBT mode:
Press the power switch and the "L4+" button at the same time: Turn on the
controller and enter D16 LBT mode, then the mode indicator light will turn solid yellow.
3. Charging system and battery installation instructions
Power charging indicator status:
When Red LED is solid: charging is in progress.
When Green LED is solid: charging is finished.
Note: Use a 5V-1A adapter to charge. When the voltage is low, it will alarm. Please
recharge when low.
Battery & Charging
The E8 Transmitter is compatible with a 18650 battery, with a working voltage of 4.3V-3.3V.
When you need to reinstall the battery, remove the battery compartment cover and install
the battery according to the correct polarity (the negative pole is on the spring side of the
battery compartment). Confirm that the battery compartment cover and the battery
compartment are perfectly matched then push forward until locked. If the battery is not
installed correctly, charging and starting cannot be performed correctly.
The remote control is charged with the micro USB at the bottom. After the USB cable is
inserted, the power charging indicator status:
When the indicator light is solid red: charging
Solid green indicator light: charging is full
Note: Use 5V-1A adapter for charging and micro USB cable for charging. When the voltage
is low (3.3V), it will alarm. Please charge when battery is low.
