em@x
52
Programming / End of cooking times
This function stops cooking at a certain point of time. Put the food into the oven.
Set the oven function and temperature.
1.
Press mode until you see
End
on the display.
2.
Use
+
and
-
to set the end of a cooking time (see § setting of the time of the
day).
3.
Press
↔
to confirm. The time of the day and the symbols
A
and
are
indicated on the display. While doing so, the oven will start operating.
4.
The timer switches off the appliance when reaching the set point of time. An
acoustical signal sounds. The symbol
A
starts flashing. Set the oven function
and temperature to 0. You can cancel the acoustical signal by pressing any
button for less than 3 seconds. Press
↔
for more than 3 seconds and the
appliance changes to manual mode.
Programming / Start and duration of cooking times
This function starts cooking at a certain point of time with a certain duration. Put
the food into the oven. Set the oven function and temperature.
1.
Press
↔
until you see
Dur
on the display. Use
+
and
-
to set the duration of the
cooking time. Press
↔
to confirm. The time of the day and the symbol
A
are
indicated on the display.
2.
Press
↔
until you see
End
on the display. Use
+
and
-
to set the end of the
cooking time. Press
↔
to confirm. The time of the day and the symbol
A
are
indicated on the display. The symbol is off until the cooking time begins.
You can set a period of time of 23:59 hours after the point of time you obtain
when adding the cooking time and the time of the day.
The appliance starts operating at the point of time you obtain when subtracting the
cooking time from the set end of the cooking time. The appliance stops operating
when reaching the set end of the cooking time. An acoustical signal sounds and the
symbol
A
flashes. Set the oven function and temperature to 0. You can cancel the
acoustical signal by pressing any button for less than 3 seconds. Press
↔
for more
than 3 seconds and the appliance changes to manual mode.
When you have programmed this function, you cannot change one of the time-
factors. You must cancel the programme and change to the relevant mode to
change a time -factor. If you want to alternate your programming you have to
change the setting of the current mode for re-programming according to the steps
named above.
