The system operation is 24Vdc only and current rating is 5A per 10 m strips. Therefore, a 120W minimum power supply is
required to turn on the light in full brightness.
5. ELECTRICAL INSTALLATION
120W
9.5m
Rated power
LED Strip length
240W
19m
Locate the power supply nearby the LED strip and connect the terminal wiring. The recommended distance is as below table.
Watts of
light
120W
18AWG
0.82mm²
2m
17AWG
1.04mm²
2.5m
16AWG
1.38mm²
3m
14AWG
2.07mm²
4m
12AWG
3.29mm²
8m
10AWG
5.62mm²
12m
1. Connect the Red wiring of LED strip to Red wire of Power Supply.
Black-GNG
Red-24V
AC Mains
Waterproof Connector
24VDC wiring diagram
GLOW+LED STRIP
2. Wiring diagram with dimmer
6. HOW TO USE GLDIYSC TO CUT THE STRIP AND END CAP ASSEMBLE
If it is necessary to cut the LED strip to fit into the layout, use the GLCUTTER to cut the length where marked for the “Dotted
Line” or “Scissor Mark”. The cut section must have the appropriate IP rated cap flex accessory to maintain water proof IP
ratings.
Follow the steps below for end cap assemble after cutting.
Cutting Mark
Anti-skidding
clip
Aluminum
mounting piece
Rubber gasket
Blank end
Screw
GLCUTTER
GLOW
+
LED
STRIP
-V(Black)
+V(Red)
AC
Mains
V+
V-
24V
Power
Supply
Connect
to
LED
STRIP
+
-
Dimmer wiring diagram
waterproof
connector
ELECTRICAL INSTALLATION P6
