A
B
C
D
1
2
3
5
4
Fig.1
200 mm
min
200 mm
min
200 mm
min
1200 - 1400 mm
Fig.2
Fig.3
Fig.4
Fig.5
Fig.6
Fig.7
Fig.8
2
3
1
4
6
5
1
2
GB
GB
13
14
Package contents:
• EV charging station
• 2x RFID cards
• Wall mounting material
• Opening tool
• Cable hook
• Instruction manual
Mounting
WARNING!
A damaged EV charger must not be mounted under any circumstances.Please inform your dealer
immediately in case of damage. Installation and wiring must be carried out by a specialist company.
NOTICE:
The charging station is equipped with an integrated all-current sensitive difference current
sensor (RCMU). Each charging station must also be connected via its own residual current
device (RCD) type A (rated residual current 30mA) and a circuit breaker (CB) tripping
characteristic C, rated current 25A. No other consumers may be connected.
Product overview
1.
RFID Reader / Status LED
2.
Supply cable
3.
Charging cable
4.
Charge control button
5.
Type 2 plug
Wall mounting
Mounting accessories:
A |
4 x dowel 6x40
B |
4 x screws 9x38
C |
2 x screws M4 4x8
D |
1 x retaining plate
NOTICE:
It is recommended to install the charging station in a place with good ventilation, out of direct
sunlight and protected from wind and rain.
To ensure good ventilation, you should mount the charging station vertically and with
sufficient space (Fig.1).
1.
Place the retaining plate (D) at the location of a
load-bearing wall where you want to place the
charging station. Pay attention to the minimum
distances (Fig.1). Mark the drill holes (Fig.2).
Drill 4 holes with a diameter of 6 mm and a depth
of at least 50 mm into the wall.
2.
Insert and countersink the dowels (A) into the
drilled holes (Fig.3).
3.
Screw the retaining plate firmly to the wall using the
screws (B) (Fig.4).
4.
Place the charging station on the retaining plate with
the rear side facing upwards (Fig.5).
5.
Fix the charging station with the screws
(C) on the left and right of the retaining plate (Fig.6).
Opening the housing cover
RISK OF ELECTRIC SHOCK!
Make sure that the charging station is de-energized
when opening the cover!
Only qualified personnel are allowed to open the housing!
1.
Remove the screw on the bottom of the device
(Fig.7/1).
2.
Insert the tip of the housing opener included in the scope
of delivery between the two parts of the device and
lever the cover forward (Fig.7/2).
Proceed as described in Fig.8. After that, cover can be
removed to the front.
3.
To close, place the protective cover on the housing and
press until the cover audibly clicks into place.
Fix the cover again from below with the screw.
