USER MANUAL - 2020
21
7.9 Battery pack
Epure Battery
Escape Battery
The battery is inside the battery pack. The casing of the battery pack
makes it possible to protect all the cells composing the battery
against the aggressions of the external environment. Up to a certain
limit, the battery pack is protected against splashes of water, dust
and other harmful elements for the battery (rain, driving in dry
weather). However, the user must be careful not to use the Epure
motorcycle under extreme conditions, otherwise the vehicle may be
damaged irreversibly (full immersion of the motorcycle).
The battery pack uses a set of lithium-ion cells assembled in series.
These elements have been tested to obtain the best performance
while maintaining maximum reliability.
It is important to note that the maximum capacity of the battery will
be obtained after
about 10 cycles of full charge / discharge of the
vehicle.
The battery pack is dimensioned to achieve the best possible
reliability / performance ratio. It is possible, however, that certain
maintenance operations will be carried during the lifetime of the
vehicle.
All work on the electric components of the motorcycle, and
especially on the battery pack, is accompanied with risks of causing
electric arcs if precautions are not taken. Working on the electric
components of the motorcycle requires special training,
qualifications and tools.
Therefore, all work that is not explicitly described in this manual,
and which concerns an electronic device, must be carried out only
by an
Electric Motion
qualified electrician.
Do not open the motor or the vehicle battery pack. If there are any
problems with these items, contact
Electric Motion
Customer
Service.
When receiving the motorcycle, it is important to charge the
battery pack according to the recommended battery charging
procedure.
Be sure to turn off the motorcycle after each use or whenever
the motorcycle is not used for a long period of time. Make sure that
all the lights are turned off when the ignition key is switched off.
