EM TEST
VDS 200 Series
Manual for Operation
V 5.19
16 / 57
3.
Operation
3.1. Description of the menus
The simulator VDS 200 is operated by an easy menu control system.
Seven function keys are available to select parameters and functions. All
functions are indicated on the display; max. 8 lines and 40 characters.
The selected parameter is blinking and can be changed by turning the knob (incr./decr.).
:
The digit to be changed can be selected with the cursor (
).
- Setted values are direct indicated on the screen.
- Status on the bottom lines shows the desired status after pressing the function key.
ESC
:
ESC will take you back to the previous level in the menu and set the displayed
values. The latest settings are stored automatically and will be recalled when the
menu is selected again.
EXIT
: The firmware will reset to the main screen.
EM TEST
V D S 2 0 0 N 10
Voltage Drop Simulator
V 3.04
Waveforms
SWN: 001234
The serial number and the version number SWN are
used for tractability reasons. These numbers are listed
in the test reports and calibration certificates. These
numbers also are listed within the test reports
generated by the iso.control software
Start-up display example VDS 200N10
3.2. Main Menu
MAIN MENU
F1 : Wave Simulator
F7 : Service
F1
F2
F3
F4
F5
F6
F7
F1 Wave Simulator.
Within this part the internal low frequency high power amplifier
together with the internal signal generator is used to generate
arbitrary waveforms as required in different standards.
The operator can use the generator in this mode as a
- DC power supply source
- High power arbitrary wave generator with integrated test routines
- or simply as a Low Frequency Amplifier
The low frequency amplifier can be remote controlled by any external arbitrary generator. External generators
shall be connected at the rear part of the equipment. Any waveform can be generated up to the upper bandwidth
of the unit.
F7 Service
Set-up, self-test, addresses of EM Test can be selected and displayed.
