EM TEST AutoWave, Руководство по эксплуатации

Страница: 30 / 45

EM TEST AutoWave
Manual for Operation V 5.9.1 30 / 45
3.2.3. DC Source
Parameter to control the connected voltage source. This setting must be done for each channel CH1...CH4 with
a connected voltage source. AutoWave calculates automatically the correct output signal for controlling the
source.
Channel Selected output channel for setting the parameters
Source Source design for polarity output
Input U Max. input signal to control the power supply from
AutoWave ( individual each channel)
Output U Max. output signal of the power source to the DUT
Vset Manually setting DC output voltage of each channel.
(Vset ≤ Output)
Channel CH1, CH2, CH3, CH4
Source Unipolar , Bipolar
Input U Voltage range [ 0V ... 10.00V ]
step 0.01
Output U Voltage range [ 0V...999.99V ]
step 0.01
Examples for VDS
Unipolar
10.00V
30.00V or 60.00V
Mode of value setting
The user has a choice of two modes to edit values for voltage and frequency parameters.
The “
normal
” mode is the usual one, and is done in two steps:
- first step to setup the integer part
- second step to setup the fractional part.
The “
all step editor
” mode selects each digit from left to right and the value is parsed sequentially.
Toggle between the two edit modes with the button MODE
“Normal” Mode
30.00V

SETUP

30.00V

SETUP

next value to setup
Available keys:
STOP: Ends the editing, discarding any changes
LEFT:
Decrease the value with acceleration
RIGHT: Increase the value with acceleration
SETUP: Move from integer part to fractional part and then validate the setting
MODE: Change editing
mode to “
All Step Edition
”
Note: In this mode, when you are setting the integer part, the fractional is set to zero.
“All Step Editor” Mode
30.00V

SETUP

30.00V

SETUP

30.00V

SETUP

30.00V

SETUP

next value to setup
Available keys:
STOP: Ends the editing, discarding any changes
LEFT:
Decrease the value with acceleration
RIGHT: Increase the value with acceleration
SETUP: Move the edited digit step by step from the left to right position / validate the setting
MODE: Change editing
mode to “
Normal
”
Note: in this mode, any acceleration on LEFT or RIGHT key is disabled.