EM Phaser EM-MBC1, Инструкция по установке и эксплуатации

Страница: 3 / 5

4 5
Congratulations!
On your purchase of the EMPHASER 2-way system dedicated for Mercedes-Benz vehicles.
If you plan on installing this speaker system by yourself, please read the following instructions
carefully before you attempt the installation.
For any further information about this product, please contact your authorized EMPHASER
dealer.
SET CONTENT
Carefully remove the loudspeakers, crossovers and the accessories from the gift box and
check whether all parts are in good undamaged condition, and match with the set contents
listed below:
■ 1 Coaxial speaker
■ 1 highpass crossover
■ 1 manual
ASSEMBLY
This set is compatible with a variety of Mercedes-Benz vehicles. For step by step instructions
on how to disassemble the original loudspeakers of your specific vehicle correctly, please
contact your Mercedes-Benz service workshop. The following instructions for the C205
model are to serve as an example for all models.
Gently lever the center speaker cover off with a wide plastic wedge. Start at the front and
work your way to the windscreen piece by piece. The cover is attached with clips in the places
marked with rectangles.
The original speaker is plugged in at three points on the panel. If necessary, use a plastic
wedge to lever out the speaker. To unlock the connectors, use either a small screwdriver or
a paper clip. Connect the supplied crossover to the original connection cable (gray / gray
black) and the other end to one of the two connection terminals of the EM-MBC1.
Connection variant 1:
If the original center speaker has two connections, you must connect the cable for the SOS
emergency call function without the included crossover, otherwise an error message will
appear in the radio display. This error message disappears automatically as soon as the
loudspeaker has been correctly connected (i.e. without the crossover) to the SOS cable.
Connection variant 2:
If the original center has only one connection (SOS function only), you must connect the cable
for the SOS emergency call function without the included crossover, otherwise an error mes-
sage will appear in the radio display. This error message disappears automatically as soon as
the loudspeaker has been correctly connected (i.e. without the crossover) to the SOS cable.
For the second terminal, you either connect the original speaker cable with the provided
crossover to the EM-MBC1, or connect it with the cable from your additional amplifier directly.
Stow the cables and crossovers and place the speaker on top of the three mounting holes.
Now push the speaker at the ends with the mounting balls in the mounting holes until they
are firmly locked.
Mount the cover. To do this, place the clips of the cover on the corresponding holes and
gently push the cover down until the clips snap into place.