6
i-2 User Manual
www.emacoustics.co.uk
Processing
The i-2 incorporates a three-way passive crossover network to split the full-range input signal to the relevant drive
units. Under no circumstances should you attempt to disconnect or bypass this network – doing so is likely to
damage your loudspeaker.
Like all EM Acoustics products, the i-2 requires no external EQ to function as intended. Depending on the nature
of your desired application, you may well wish to use a system processor for delays and room EQ. It is also
recommended for higher-SPL applications that a high pass filter should be used – with a minimum of 24dB/Octave
Butterworth slope, around or above 90Hz. This will prevent unwanted low frequencies (which the i-2 is not
capable of reproducing) from forcing the drive units to over-travel and will avoid damage.
If you are in any doubt whatsoever over correct processor settings, please do not hesitate to contact your EM
Acoustics representative or contact us at the factory directly.
