6
5.5 POWER SUPPLY AND WALL PAD
TO CONTROL BOARD CONNECTION
NOTE!: The 115 VAC electrical connection must always
be made by an expert who has the corresponding
license. The instructions shown here do not permit
amateurs to make the electrical connection, and only
serve as additional information for an expert who is
employed to do the work!
Make the connection to the unit via the 5 feet long cable
with plug (17) to a line that is protected with a 15 A fuse
in the vehicle. It is mandatory that connection is carried
out with care while observing the correct cable colors!
Open the unit cover and plug connector of wall pad
cable (16) into the control board. The cables must be
long enough for the unit to be pulled out of the false
floor with the cables attached. All cables must be
secured with clamps!
An insulating device for providing all-pole insulation
from the mains with contact clearance of at least 0.14
inch must be provided at the vehicle end for carrying
out maintenance and repair work.
6. OPERATING INSTRUCTION
Must be carefully read the operating instructions and
the “Safety Instructions” in preference to start unit!
The vehicle owner is responsible for correct operation
of the appliance.
Startup
Before switching on the unit, please be sure to check
that the camp site has proper power supply fusing
(115 V / Min. 10 A).
Note: The default power supply cable with plug is 5 feet length, In order to prevent the power cable of the
RV from overheating (minimum cross-section 3 x 2.08 mm²) and the cable drum must be fully unwound.
